CHANGING THE REMOTE FREQUENCY OF YOUR NUMBER 1 (IR) OR NUMBER 2 (UHF) REMOTE

1. GO TO THE FRONT OF THE RECEIVER AND PRESS THE SYSTEM INFO BUTTON

2. FOR BOTH TUNERS YOU WILL SEE A SECTION WHERE IT SAYS REMOTE ADDRESS

3. FOR EACH REMOTE THAT YOU WANT TO REPROGRAM, PRESS AND HOLD THE SAT BUTTON IN THE UPPER LEFT CORNER OF THE REMOTE UNTIL ALL THE BUTTONS LIGHT UP THEN RELEASE

4. NOW SELECT A DIFFERENT NUMBER THAN WHAT IS SHOWN ON THE SCREEN FOR THAT REMOTE BY PRESSING THE NUMBER BUTTONS ON THE REMOTE ( FOR EXAMPLE IF THE CURRENT NUMBER IS 1 THEN SELECT 2) THEN PRESS THE # BUTTON IN THE LOWER RIGHT CORNER.

5. PRESS RECORD (RED BUTTON IN THE MIDDLE OF THE REMOTE)

6. THE NUMBER FOR THE REMOTE ADDRESS WILL CHANGE FROM 1 TO 2

7. ON THE FRONT OF THE RECEIVER, SELECT DONE

YOU ARE DONE. TEST THE REMOTE BY USING AS PER NORMAL

IF THE RECEIVER DOES NOT OPERATE NORMALLY, YOU MAY NEED TO CHANGE THE BATTERIES OR REPEAT THE ABOVE STEPS

PROGRAMMING YOUR DISH REMOTE TO YOUR TV

PROGRAMMING YOUR DISH REMOTE
TO PROGRAM YOUR DISH REMOTE TO OPERATE YOUR TV FOLLOW THESE STEPS:

1.PRESS AND HOLD THE WHITE TV BUTTON UNTIL ALL THE BUTTONS LIGHT UP THEN RELEASE
2.THE TV BUTTON SHOULD BE FLASHING
3.PRESS THE TOP RED POWER BUTTON ONCE AND RELEASE
4.THE TV BUTTON SHOULD STAY LIT
5.NOW PRESS THE CHANNEL UP BUTTON REPEATEDLY UNTIL THE TV TURNS OFF
6.PRESS THE # BUTTON TO LOCK THE CODE
7.TEST BY PRESSING THE POWER BUTTON
THE TV SHOULD TURN ON
IF THE TV DOES NOT TURN ON, YOU PROBABLY PASSED THE CODE
TO CORRECT, FOLLOW STEPS 1-4 AND WHEN YOU GET TO STEP 5, PRESS CHANNEL DOWN INSTEAD OF UP.
DONE
YOUR REMOTE IS NOW PROGRAMMED.